|
Densi-Proof plus Surface Sheen |
|
PERMANENT CONCRETE WATERPROOFER WITH A BUILT-IN FLEXIBLE MEMBRANE THAT LOOKS GOOD. EXCELLENT RESISTANCE TO OILS AND ACIDS.
OIL & ACID RESISTANT ready for use DO NOT DILUTE
- Excellent for curing
- One time permanent application
- Easy and safe to apply
- Can penetrate beyond 200mm
- Waterproofs inside and outside
- Preserves concrete’s integrity
- Makes concrete more durable
- Easy snow/ice removal
- Low slip, buffable coating
- Prevents efflorescence
HOW TO APPLY:For newly placed unused concrete ONLY. For existing, used and old concrete a two part system must be used. Densi-Proof™ will decontaminate and purge deep seated unwanted substances to the surface and these need to be removed prior to finishing with Surface Save & Seal™ or Luster Shield™Note: In hot climates, mist-wet the surface with water and remove any puddles prior to application..
- Use low pressure airless sprayer complete with 60cm wand and a .019” fan tip spray jet.
- Hold spray tip a minimum 150mm from surface.
- With an overlapping spray pattern of 50%, achieve a minimum rate of 4.52 per litre. Rate will depend on the porosity or openness of the concrete.
- Begin applying at the lowest level elevation. For example, walls and slopes should be applied side to side, from the bottom up.
- Before the coating dries, using a short nap paint roller, push excess product form the low points in the floor and evenly distribute back over the higher spots. This will also give a higher finished sheen.
HOW TO USE AS A CURE:
- Follow normal application instructions, except, use non-atomizing spray apparatus such as a pump tank sprayer. However, if surface is allowed to harden, you must then use an airless spray unit (at low pressure to avoid disturbing the top).
- Apply to the newly placed finished surface as soon as it is practical to walk on with out damaging.
- Apply at the rate of 4.5m2 per litre for broom finished concrete and hard or steel troweled concrete..
Ready to Use DO NOT DILUTE - Mix thoroughly before application, use a paint mixing paddle on a drill for 2 minutes.
OTHER IMPORTANT NOTES: Use only on green or recently placed concrete. Densi-Proof plus Surface Sheen™ will seal in visible stains and bring hidden contaminants to the surface of old contaminated concrete and seal them in. On existing conrete use a 2 part system of Densi-Proof™ then Luster Shield™
- Wax, paint or any thing else restricting access to concrete’s interior must be chemically or mechanically removed for PROTECT CRETE® Densi-Proof plus Surface Sheen™ to penetrate.
- Areas of high porosity have a faster penetration rate. These areas appear dry immediately after spraying and will require additional product.
- Mix thoroughly before application, use a paint mixing paddle on a drill for 2 minutes.
- Do not apply on frozen substrate or when temperature is near freezing.
- PROTECT CRETE® Densi-Proof plus Surface Sheen™ may etch glass or dull brushed and shiny aluminium and can be difficult to remove from other surfaces once it dries. Cover and mask surrounding surfaces or rinse immediately if sprayed.
- We recommend the use of a painters mask during application. Refer to MSDS available from www.protectcrete.com.au
- Ensure you contact your nearest PROTECT CRETE office for full technical bulletins and latest application procedures.
User Friendly - Non Toxic - Non Flammable - Zero VOC - Environmentally Safe - Odourless
Manufacturers of the world’s most technically advanced systems for permanent concrete repair, moisture proofing and protection treatments.
HIGHLY PENETRATIVE SHEEN SURFACE PRESERVATION TREATMENT FOR NEW PLACED CONCRETE - OIL & ACID RESISTANT
|
|
Last Updated on Friday, 26 March 2010 05:02 |
