|
Written by ITSimple Admin
|
|
Sunday, 18 January 2009 03:30 |
CONCRETE DENSIFYING SOLUTION -
Penetrates to extraordinary depths permanently.
Waterproofs and improves new or old concrete.
- Purges out years of contamination and odours from old slabs
- Early access, trafficable in one hour, minimum disruption
- Tested to 150ft (45.7m) of Hydrostatic pressure and 300ft (91m) field tests
- Will accept floor coverings or coatings after 24 hours
- Protects against urine and chemical ingress.
- Environmentally safe and user friendly
- Increases surface abrasion resistance
- One time permanent application.
- Forms a permanent colloidal gel
- Minimizes acid/chemical attack
- Makes concrete more durable
- Easy and safe to apply
- Prevents efflorescence
HOW TO APPLY:
- Note: in hot climates, mist-wet the surface with water and remove any puddles prior to application.
- Use medium to high-pressure airless sprayer complete with 60cm wand and a 0.019" fan tip spray jet.
- Hold spray tip 150mm from surface.
- Apply at point of saturation at the approximate rate of 4.5m2 per litre with an overlapping spray pattern of 50%.
- Begin applying at the lowest level elevation. For example, walls and slopes should be applied side to side, from the bottom up.
HOW TO USE AS A CURE:
- Follow normal application instructions, except use non-atomizing spray apparatus such as a pump tank sprayer. However, if surface is allowed to harden and it is longer than 24 hours from placement you must then use an airless spray unit (at low to medium pressure to avoid disturbing the top).
- Apply to the newly placed finished surface as soon as it is practical to walk on without damaging the surface.
- Apply at the rate of 4.5m2 per litre for broom finished concrete or hard and steel troweled concrete.
OTHER IMPORTANT NOTES:
- Wax, paint or anything else restricting access to concrete's interior must be chemically or mechanically removed for Protect Crete Densi-Proof to penetrate. Test with droplets of water on the concrete surface, if the water does not penetrate into the concrete with in 2 minutes then the Densi-Proof will not function properly and may be ineffective.
- Areas of high porosity have a faster penetration rate. These areas appear dry immediately after spraying and will require additional product.
- Do not apply on frozen substrate or when temperature is below 3oC.
- When applying paint, adhesives or any other coatings, wait 24 hours after sealing with Protect Crete Densi-Proof, then lightly abrade/sand or flush clean surface with water and allow to dry before coating. Always follow coating manufacturers surface requirements.
- For very oily or greasy surfaces, use Protect Crete Densi-Proof plus Cleaner (or clean with detergent and high pressure hot water prior to application). Consult your nearest Protect Crete office for advice and specification for your contaminated site.
- Special note for concrete block: Block quality, cement content and porosity size can vary widely. Some may never be completely waterproofed and will only be damp proofed. Spray twice.
- Protect Crete Densi-Proof may etch glass or dull brushed and shiny aluminium (the same as wet concrete) and can be difficult to remove from other surfaces once it dries. Cover and mask surrounding surfaces or rinse immediately if sprayed.
- We recommend the use of a painters mask during application. Refer to Densi Proof MSDS
User Friendly - Non Toxic - Non Flammable - Zero VOC - Environmentally Safe - Odourless
Manufacturers of the world’s most technically advanced systems for permanent concrete repair, moisture proofing and protection treatments.
CONCRETE DENSIFYING SOLUTION - PERMANENTLY WATERPROOFS AND IMPROVES NEW OR OLD CONCRETE
|
|
Last Updated on Wednesday, 05 May 2010 00:20 |
